Page
5
WDI1210 user manual.doc
FUNCTIONS AND PREPARATION FOR WASHING
Detergent dispenser
The detergent dispenser is divided into four compartments
1.
Pour washing detergent in this compartment for the prewash
cycle (MAX 45 grams).
2.
Washing detergent in this compartment for the wash cycle
(MAX 130 grams).
3.
Pour bleaching liquid into this compartment following the
advice on the packing (do not exceed in quantity over the
filter grid)
4.
Pour softener into this compartment following the advice on
the packing (max 60 ml - do not exceed in quantity over the
filter grid)
Close the dispenser after the detergent compartments have been filled. It is recommended
to use non-foaming detergents and a softener in case of hard water.
Cleaning of the dispenser
It is advisable to clean the compartment regularly, as explained below: - press lever (A) and
slide the compartment out of it’s housing;
•
Remove the siphon cover of compartment 3-4;
•
Wash everything with running water;
•
Replace the siphon cover in the compartment making sure it fits perfectly in its housing;
•
Replace the compartment in its housing.
Door
Use the handle to open the door.
During the wash cycle, a special safety device keeps the door locked. To
open the door, turn off the machine using the ON-OFF switch and wait 2
minutes before turning the handle to open the door.
Sorting clothes
Each of the following groups should be sorted and washed separately
according to the cycle specified in the cycle table:
•
White and resistant colored fabrics
•
Non-resistant colored fabrics
•
Delicate fabrics (silk, polyester, nylon, etc.)
•
Wool
This Washer Dryer is designed to WASH only, to DRY only or to WASH & DRY, for
instructions on how to dry cloths, read the “Drying” section carefully.
Washing Operations
•
sort
the clothes
•
Place them uniformly inside the drum
•
Select the most suitable cycle for the fabrics (see wash cycle table)
•
Set the cycle by following the instructions in the "control panel" section and turn on the
machine by pushing the ON/OFF button.
WARNING:
Set the cycle only when the machine is off. - Always turn the control dial
clockwise. If you pass the desired position, make a complete turn and reset the dial to the
exact position.