19/33
6.1.3．How to remove the evaporator
The process: Remove the shelves→Remove the control panel film→Remove the screws→
Remove the display supporter →Remove the middle electrical box→ Remove the screws
→Remove the upper and lower air-duct board.→ Remove the inner air-duct board
→ separate the evaporator from the compressor and dry filter on the joints.
You can see the evaporator is joint to suction pipe and capillary.
（Fig.7 ）
Heat the joint E,G
（Fig.17 ）
in the compressor room, and disconnect the pipe from compressor by using the
plier. Then remove the evaporator and capillary and suction pipe upward.
Fig.7
C
D
E
F
G
H
I
J
B
A
