11
Please keep this instruction manual for future reference
Instruction manual VEL410BK/CO/GD
I N S TA L L AT I O N
P R E PA R E F O R T H E I N S TA L L AT I O N :
Before beginning the installation, ensure the extractor is not connected to the mains supply.
The cooker hood should be placed at a minimum distance of
650-760mm above the hob. It is the manufacturer of the hob
who determines the clearance required and the clearance quoted
by the hob manufacturer must be followed. In the absence of
any instructions supplied with a gas hob, the minimum distance
between the hob and the hood must be at least 760mm.
WARNING :
The electrical connection must correspond to the electrical requirement detailed on the rating
plate. This is located inside the cooker hood.
After installing, check the appliance is operating correctly by selecting each speed and
switching the light on and off.
The appliance is suitable for recirculation only, and cannot be vented externally. In recirculation
mode the air and fumes conveyed by the appliance are cleaned both by a grease filter and by
an active charcoal filter, and put again into circulation.
When installed above a gas hob or range cooker, do not use all the gas burners simultaneously
for prolonged periods of time at the maximum setting (max. 15mins). There can be a risk of
burns if the housing or extractor surfaces become hot, and there is also a risk that the extractor
can become damaged due to excessive heat. If 3 or more burners are used simultaneously,
operate the extractor at the maximum setting.
Never operate the gas hob without pans situated on the burners as the excess heat can
damage the extractor.
650-760mm