Failure to clean the filter will extend drying times and cause the safety cut−out to operate.
Pull the filter upwards and away from the appliance.
Remove threads or fluff by hand or with a soft brush.
Slide the filter back.
Wash the filter occasionally in detergent solution and with a soft brush to remove small
particles.
To avoid minor faults
If the clothes are not dry after normal drying time:
Check that you used the correct heater setting.
Check the fuse in the moulded plug.
Check that the lint filter has been cleaned. A blocked filter will restrict the airflow.
Check that your dryer is heating, the right side below the door should feel warm after the
first 10 to 15 minutes of its programme. Failure to heat may indicate the safety cut−out has
operated. To reset, simply press the red button at the rear of the machine. If operated, a
sharp click will be heard. This cut−out only operates if the air flow is severely restricted so
make sure the filter is clean, the air inlets and outlets at the front and back are not blocked,
and that all other restrictions are removed before restarting. If the cut−out continues to
operate after checking the above points, you should contact Caple Service.
Your dryer is designed to operate in a room temperature range of 5°C to
30
° C.
Door reversal
Appliance door
The door
on the dryer can be positioned either with the left or right hand hanging.
Please follow illustrations below to change the door position.
