
Instruction manual RFF730
Please keep this instruction manual for future reference
9
INSTALLING AND OPERATING YOUR FRIDGE
Before starting to use your fridge, you should pay attention to the following points:
- Operating voltage for your fridge is 220-240 V at 50Hz.
- Mains cord of your fridge has a grounded plug. This plug should be used with
a grounded receptacle that has a 13 ampere fuse minimum. If you don’t have a
receptacle confirming with this, please have it done by a qualified electrician.
- Caple do not take the responsibility for damages that occur due
to ungrounded usage.
- Place your fridge in a place that would not be exposed to direct sunlight.
- Your appliance should be at least 50 cm away from hobs, Gas ovens and heater
cores, and should be at least 5 cm away from electrical ovens.
- Your fridge should never be used outdoors or left under the rain.
- When your fridge is placed next to a deep freezer, there should be at least 2 cm
between them to prevent humidity on the outer surface.
- Do not place anything on your fridge, and install your fridge in a suitable place so
that at least 15 cm is available on the upper side.
- The adjustable front legs should be stabilized at an appropriate height to allow
your fridge to operate in a stable and proper way. You can adjust the legs by
turning them clockwise (or in the opposite direction). This should be done before
placing food in the fridge.
- Before using your fridge, wipe all parts with warm water
added with a tea spoonful of sodium bicarbonate, and
then rinse with clean water and dry. Replace all parts
after cleaning.
- Install the distance adjustment plastic (the part with
black vanes at the rear) by turning it 90° as shown in the
figure to prevent the condenser from touching the wall.
- Refrigerator should be placed against a wall with a free
distance not exceeding 75 mm.
RFF730 Free Standing Fridge Freezer.indd 9
13/10/2016 12:58