Instruction manual Di642 37
Please keep this instruction manual for future reference
WAT E R S U P P LY A N D D R A I N
C O L D WAT E R C O N N E C T I O N
Connect the cold water supply hose to a threaded 3/4 inch
connector and make sure that it is fastened tightly in place. If the
water pipes are new or have not been used for an extended period
of time, let the water run to make sure that the water is clear. This
precaution is needed to avoid the risk of the water inlet to be
blocked and damaged.
C O N N E C T I O N O F D R A I N H O S E S
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink,
making sure to avoid bending or crimping it. The height of drain pipe must be less than 100cm.
The free end of the hose must not be immersed in water to avoid the back flow of it.
WAT E R S U P P LY A N D D R A I N
C O L D W A T E R C O N N E C T I O N
A B O U T T H E S A F E T Y S U P P LY H O S E
The safety supply hose consists of the double walls. The hose’s system guarantees its intervention
by blocking the flow of water in case of the supply hose breaking and when the air space between
the supply hose itself and the outer corrugated hose is full of water.
WA R N I N G
A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the
hole plugged.
H OW TO C O N N E C T T H E S A F E T Y S U P P LY H O S E
1. Pull The safety supply hoses completely out from storage compartment located at rear
of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4inch.
3. Turn water fully on before starting the dishwasher.
H OW TO D I S C O N N E C T T H E S A F E T Y S U P P LY H O S E
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
safety supply hose
ordinary supply hose
Connect the cold water supply hose to a
threaded 3/4 inch connector and make sure that
it is fastened tightly in place. If the water pipes
are new or have not been used for an extended
period of time, let the water run to make sure
that the water is clear. This precaution is needed
to avoid the risk of the water inlet to be blocked
and damaged.
