Instruction manual DI631
Instruction manual DI631
40
41
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
P O S I T I O N I N G T H E A P P L I A N C E
Position the appliance in the desired location. The back should rest against the wall behind it, and
the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and
drain hoses that can be positioned either to the right or the left sides to facilitate
proper installation.
H OW TO D R A I N E X C E S S WAT E R F R O M H O S E S
If the sink waste is more than 1000mm from the floor, the excess water in the hoses cannot be
drained directly into the sink. It will be necessary to drain excess water from hoses into a bowl or
suitable container that is held outside and lower than the sink.
WAT E R O U T L E T
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure
that the water inlet hose is not kinked or squashed.
E X T E N S I O N H O S E
If you need a drain hose extension, make sure to use a similar drain hose. It must be no longer
than 4 metres, otherwise the cleaning effectiveness of the dishwasher could be reduced.
S Y P H O N C O N N E C T I O N
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the
sink, making sure to avoid bending or crimping it. The top of the hose must be less than 1000mm
from the floor.
S TA RT T H E D I S H WA S H E R
The following things should be checked before starting the dishwasher:
1. The dishwasher is level and fixed properly.
2. The inlet valve is open.
3. There is no leakage at the connection points.
4. The wires are tightly connected.
5. The power is switched on.
6. The inlet and drain hoses are not knotted.
7. All packing materials and printings should be taken out from the dishwasher.
T R O U B L E S H O OT I N G
B E F O R E C A L L I N G F O R S E RV I C E
T Y P E P R O B L E M
P O S S I B L E C AU S E S
W H AT TO D O
TECHNICAL PROBLEMS
Dishwasher
doesn’t start
Fuse blown, or the circuit
breaker acted
Replace fuse or reset circuit breaker. Remove any other appliances
sharing the same circuit with the dishwasher.
Power supply is not
turned on
Make sure the dishwasher is turned on and the door is closed securely.
Make sure the power cord is properly plugged into the wall socket.
Water pressure is low
Check that the water supply is connected properly and the water is
turned on.
Door of dishwasher not
properly closed.
Make sure to close the door properly and latch it.
Water not
pumped from
dishwasher
Kink in drain hose
Check drain hose.
Filter clogged
Check coarse filter (see section titled) the “ Cleaning The Filter “
Kitchen sink clogged
Check the kitchen sink to make sure it is draining well. If the problem is
the kitchen sink not draining, you may need a plumber.
GENERAL PROBLEMS
Suds in
the tub
Improper detergent
Use only the special dishwasher detergent to avoid suds. If this occurs,
open the dishwasher and let suds evaporate. Add 1 gallon of cold
water to the tub. Close and latch the dishwasher, then select any cycle.
Dishwasher will drain out the water at the first step. Open the door
after draining to stop and check if the suds have disappeared. Repeat
if necessary.
Spilled Rinse Aid
Always wipe up Rinse Aid spills immediately
Stained tub
interior
Detergent with colourant
was used
Make sure that the detergent is the one without colourant.
White film on
inside surface Hard water minerals
To clean the interior, use a damp sponge with dishwasher detergent
and wear rubber gloves.
Never use any other cleaner than dishwasher detergent for the risk of
foaming or suds.
There are
rust stains on
cutlery
The affected items are not
corrosion resistant.
A programme was not run
after dishwasher salt was
added. Traces of salt have
gotten into the wash cycle.
Always run the quick wash programme without any crockery in the
dishwasher and without selecting the Turbo function (if present), after
adding dishwasher salt.
The lid of the softer
is loose
Check the lip. Ensure the fix is fine.
