Instruction manual DI631
Instruction manual DI631
30
31
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
C A R I N G F O R T H E D I S H WA S H E R
The control panel can be cleaned by using a lightly dampened cloth. After cleaning, make sure to
dry it thoroughly.
For the exterior, use a good appliance polish wax. Never use sharp objects, scouring pads or harsh
cleaners on any part of the dishwasher.
C L E A N I N G T H E D O O R .
To clean the edge around the door, you should
use only a soft warm, damp cloth. To avoid
penetration of water into the door lock and
electrical components, do not use a spray
cleaner of any kind.
WA R N I N G :
»
Never use a spray cleaner to clean the door panel as it may damage the door lock and
electrical components.
»
Abrasive agents or some paper towels should not be used because of the risk of scratching or
leaving spots on the stainless steel surface.
P R OT E C T AG A I N S T F R E E Z I N G
Please take frost protection measures on the dishwasher in winter. Every time after washing cycles
please operate as follows:
1. Cut off the electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve. (Use a pan to gather the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the dishwasher and use a sponge to soak up water in
the sump.
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
1.
Cut
off
the
electrical
power
to
the
dishwasher.
2.
Turn
off
the
water
supply
and
disconnect
the
water
inlet
pipe
from
the
water
valve.
3.
Drain
the
water
from
the
inlet
pipe
and
water
valve.
(Use
a
pan
to
gather
the
water)
4.
Reconnect
the
water
inlet
pipe
to
the
water
valve.
5.
Remove
the
filter
at
the
bottom
of
the
dishwasher
and
use
a
sponge
to
soak
up
water
in
the
sump.
P
lease
take
frost
protection
measures
on
the
dishwasher
in
winter.
Every
time after washing cycles
please
operate
as
follows
：
Cleaning the Filter
Cleaning The Door
To
clean
the
coarse
filter
and
the
fine
filter,
use
a
cleaning
brush.
Reassemble
the
filter
parts
as
shown
in
the
figures
on
the
previous
page
and
reinsert
the
entire
assembly
in
the
dishwasher
.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of the dishwasher could be decreased.
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
If
your
dishwasher
cannot
work
because
of
the
ice
build up
,
please
contact
a qualified plumber or serviceman.
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Remarks:
The entire filter assembly should be cleaned once a week.
Cleaning
the
Spray
Arms
It
is
necessary
to
clean
the
spray
arms
regularly
as
hard
water
chemicals
will
clog
the
spray
arm
jets
and
bearings.
To
remove
the
upper
spray
arm,
hold
the
nut,
rotate
the
arm
clockwise
to
remove
it.
To
remove
the
lower
spray
arm,
pull
out
the
spray
arm
upward.
Wash
the
arms
in
warm
soapy
water
and
use
a
soft
brush
to
clean
the
jets.
Replace
them
after
rinsing
them
thoroughly.
17
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
1.
Cut
off
the
electrical
power
to
the
dishwasher.
2.
Turn
off
the
water
supply
and
disconnect
the
water
inlet
pipe
from
the
water
valve.
3.
Drain
the
water
from
the
inlet
pipe
and
water
valve.
(Use
a
pan
to
gather
the
water)
4.
Reconnect
the
water
inlet
pipe
to
the
water
valve.
5.
Remove
the
filter
at
the
bottom
of
the
dishwasher
and
use
a
sponge
to
soak
up
water
in
the
sump.
P
lease
take
frost
protection
measures
on
the
dishwasher
in
winter.
Every
time after washing cycles
please
operate
as
follows
：
Cleaning the Filter
Cleaning The Door
To
clean
the
coarse
filter
and
the
fine
filter,
use
a
cleaning
brush.
Reassemble
the
filter
parts
as
shown
in
the
figures
on
the
previous
page
and
reinsert
the
entire
assembly
in
the
dishwasher
.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of the dishwasher could be decreased.
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
If
your
dishwasher
cannot
work
because
of
the
ice
build up
,
please
contact
a qualified plumber or serviceman.
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Remarks:
The entire filter assembly should be cleaned once a week.
Cleaning
the
Spray
Arms
It
is
necessary
to
clean
the
spray
arms
regularly
as
hard
water
chemicals
will
clog
the
spray
arm
jets
and
bearings.
To
remove
the
upper
spray
arm,
hold
the
nut,
rotate
the
arm
clockwise
to
remove
it.
To
remove
the
lower
spray
arm,
pull
out
the
spray
arm
upward.
Wash
the
arms
in
warm
soapy
water
and
use
a
soft
brush
to
clean
the
jets.
Replace
them
after
rinsing
them
thoroughly.
17
N OT E :
If your dishwasher cannot work because of the ice build up, please contact a qualified plumber
or serviceman.
C L E A N I N G T H E S P R AY A R M S
It is necessary to clean the spray arms regularly as hard water chemicals
will clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the arm clockwise to
remove it.
To remove the lower spray arm, pull out the spray arm upward.
Wash the arms in warm soapy water and use a soft brush to clean the
jets. Replace them after rinsing them thoroughly.
H OW TO K E E P YO U R D I S H WA S H E R I N S H A P E
A F T E R E V E RY WA S H
After every wash, turn off the water supply to the appliance and leave the door slightly open so
that moisture and odours are not trapped inside.
R E M OV E T H E P L U G
Before cleaning or performing maintenance, always remove the plug from the socket.
N O S O LV E N T S O R A B R A S I V E C L E A N I N G
To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning
products. Only use a cloth with warm soapy water. To remove spots or stains from the surface of
the interior, use a cloth dampened with water and a little vinegar, or a cleaning product made
specifically for dishwashers.
W H E N N OT I N U S E F O R A L O N G T I M E
It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug
from the socket, turn off the water supply and leave the door of the appliance slightly open. This
will help the door seals to last longer and prevent odours from forming within the appliance.
M OV I N G T H E A P P L I A N C E
If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can
be positioned on its back.
S E A L S
One of the factors that causes odours to form in the dishwasher is food that remains trapped in
the seals. Periodic cleaning with a damp sponge will prevent this from occurring.
