Instruction manual C3371
Instruction manual C3371
28
29
Please keep this instruction manual for future reference
Please keep this instruction manual for future reference
T E L E S C O P I C R U N N E R S
To assemble the telescopic runners:
-
Remove the side racks
-
Choose which shelf to use with the telescopic runner.
Pay attention to the direction in which the runner is to be
extracted, position joint ‘B’ and joint ‘C’ on the frame (see Fig.1).
-
Squeeze the bars together slightly and clip either end of the
telescopic runners on to the side racks.
-
Finally, re-fit the side racks as per below.
S I D E R A C K S A N D C ATA LY T I C L I N E R S
To install, align the 2 top holes in the catalytic liners with the 2 holes in the side of the oven cavity.
Once aligned, attach side rack by hanging these through the set of holes, and pushing them onto
the round steel clip towards the bottom.
This will secure the catalytic liners to the sides of the oven. To remove, unclip the side racks from
the side of the oven, and remove the catalytic liners.
Figure 1.
Figure 2.
F I T T I N G O V E N S H E LV E S
-
Ensure shelf orientation is correct
(see image to the right)
-
Slide into the oven at an angle until raised
back of shelf is past the safety stop on the
side runners.
-
Lower the front of shelf and push in until stop
is reached.
-
To remove oven shelves, withdraw to the stop
and raise the front of shelf to clear the stop.
Step 1
Step 2
Step 3
Step 4
Fig.1
Fig.2
Fig.3
D1
D2
F2
F1
To install, align the 2 top holes in the catalytic liners with the 2 holes in the side of
the oven cavity. Once aligned, Attach side rack by hanging these through the set of
holes, and pushing them onto the round steel clip towards the bottom.
This will secure the catalytic liners to the sides of the oven. To remove, unclip the side
racks from the side of the oven, and remove the catalytic liners.
SSiiddee rraacckkss aanndd C
Caattaallyyttiicc lliinneerrss
TELESCOPIC RUNNERS
To assemble the telescopic runners:
- Remove the side racks
hoose which shelf
- C
to use with the telescopic runner.
Pay attention to the direction in which the runner is
to be extracted, position joint ‘B’ and joint ‘C’ on the
frame (see Fig.1).
- Squeeze the bars together slightly and clip either
end of the telescopic runners on to the side racks.
Figure 1.
- Finally, re-fit the side racks as per below.
