Capitani DESIDERIO PLUS, Instruction Manual

Page: 32 / 104

30
STARTING THE APPLIANCE STEAM/VACUUM FUNCTION
Make sure the button (18) and switches (19, 20) on the handle (21) are OFF.
- Press the main switch (10) und the boiler switch (12) to turn the appliance and the boiler on.
If more power is needed and in order to accelerate the heating process, press the boiler switch super
power (11).
- Wait for the boiler to reach the appropriate operating pressure. When the green light (8) illuminates,
the appliance is ready for use.
- Select the desired steam level with the appropriate control hand wheel (14).
NOTE
Vacuum and steam power can be changed during machine operation.
Under normal operating conditions, an illuminated green warning light will indicate that pressure in
the boiler is within normal values; however, continual steam delivery causes pressure to decrease
slightly; in this case, the warning light will switch off automatically until the operating pressure value
is reached again. Even in this condition, you may safely continue with your cleaning job, since
resistances in the appliance have been proportioned to provide immediate reinstatement of the
operating pressure.
Turning on the appliance in the vacuum function:
Ensure that the switch (19) on the handle (21) is OFF.
Press the main switch (10) to switch ON the appliance in vacuum-cleaning mode. Now the appliance
is ready for use.
How to operate the appliance:
Before using the appliance, fit the desired tool to the hose handle (21). Once the tool is installed,
use the controls on the handle to operate the appliance as fit.
Using the controls on the handle, you can:
- deliver steam, by pressing the red button (18);
- vacuum, by pressing the white button (19);
- deliver detergent or water, by pressing the water/detergent delivery switch (20);
- deliver steam and vacuum at the same time, by pressing red button (18) and white switch (19).
- deliver steam and detergent at the same time, by pressing red button (18) and switch (20);
- deliver water/detergent and vacuum at the same time, by pressing switch (20) and
white switch (19).
To stop the function in use, simply turn off the relevant switch.
NOTE
If water or detergent in the tanks (9) and (15) run out, you will be alerted by a buzzer.
NOTE
When the cleaning job is completed, it is advised to leave the vacuum function enabled for a few
seconds. This will allow the recovery of any residual water and steam that are left in the ducts.