4. Place the remaining logs as shown in the following
photographs.
3. Arrange the small bark pieces onto the burner
cover plate ensuring there are air gaps between
them to facilitate air supply to the burner.
ENSURE THAT THEY DO NOT COVER THE
BURNER.
5.
6.
SPLIT LOG LAYOUT - DL700 & DL800
32
1. Insert the burner grille into position, ensuring the
pilot tab is towards the front of the fire.
2. Place the large log at the rear of the burner cover
plate. ENSURE THAT IT DOES NOT COVER THE
BURNER.
Using the Neon Embers is a requirement on this fire
ceramic layout. This product may need to be renewed
on annual service (dependant on usage) and is
available as a spare direct from Capital Fires.
1.Remove all the fibres from the pack but use only half
its contents for the short 260mm burner and half to two
thirds for the longer 420mm burner.
2. Tease the fibres out until they are almost the length
of the rear log, then form a slight arch to help keep the
electrically conductive fibres away from the ignition
electrode.
3. Place the Neon Embers back up against the rear log
then proceed with the step by step log layout, careful
adjustments can be made by repositioning the embers
until a desirable flame picture is achieved.
CAUTION: The logs are extremely fragile and must be handled accordingly. Gloves should be worn
and any inhalation of dust should be avoided. The logs must be kept away from children at all times.
Never put additional logs on the fire. Never use logs other than those originally supplied, or genuine
Legend Spare Parts.
NEVER PLACE ANY NEON EMBERS ANYWHERE
NEAR THE PILOT OR THE IGNITION
ELECTRODE, THIS WILL CAUSE A SHORT AND
IMEDIATELY SHUT DOWN THE
FIRE OR COULD POSSIBLY CAUSE EXPLOSIVE
IGNITION DELAY ON START UP.
Neon Embers placed against rear log
Summary of Contents for Designline DL400
Page 2: ......
Page 33: ...9 10 7 8 11 SPLIT LOG LAYOUT DL700 DL800 CONTINUED 33 ...
Page 38: ...SERVICE NOTES 38 ...
Page 39: ...SERVICE NOTES 39 ...
