CLEANING AND MAINTENANCE
29
Stainless Steel Burner
Pilot Assembly
2 x Securing Screws
30°
10mm
Fig. 64
Fig. 63
Fig. 62
Fig. 61
It is recommended that this appliance is serviced at regular
12 monthly intervals. The chimney or flue should also be
checked regularly to ensure that all products of combustion
are entering the flue and there is no excessive build up of
soot.
It is the users responsibility to ensure that the appliance is
kept in a clean serviceable condition.
To remove the glass door
1. Remove the two screws at the bottom of the glass door panel
(Fig. 61).
2. Hinge the door upwards by approximately 30° (Fig. 61).
3. Slide the door to the right by 10mm and remove the door from
it’s hinges (Fig. 62 & 63).
4. Clean the glass with a damp cloth. For stubborn stains use
a proprietary cream cleaner or ceramic hob cleaner.
Ceramic Components and Fuel Bed
Debris from any source should be removed with a soft brush.
Please ensure that any debris including soot deposits are
removed from the appliance and not left on the fuel bed.
It is recommended that the user should, on a regular quarterly
basis, carefully remove all ceramic components and thoroughly
clean the stainless steel burner and the pilot assembly.
Any build up of debris in this area could affect the
operation of the appliance (Fig. 64).
NOTE
: It is common to find surface cracks in the ceramic
components. This is due to the expansion and contraction of
the ceramic fibres caused by the intense heat that the burner
generates. The cracks will not affect the safe operation of this
appliance. However great care must be taken when handling
the ceramic components as they will break if handled
incorrectly. Do not use a vacuum cleaner to clean the ceramics.
Radiant Box Ceramic Liners
- Use only a soft brush to remove
any soot deposits from the ceramic liners
during cleaning as this is the only method that can be used to
remove deposits. The ceramic liners are very
delicate and should be treated accordingly.
5. Reassemble in reverse order.
Summary of Contents for Designline DL400
Page 2: ......
Page 33: ...9 10 7 8 11 SPLIT LOG LAYOUT DL700 DL800 CONTINUED 33 ...
Page 38: ...SERVICE NOTES 38 ...
Page 39: ...SERVICE NOTES 39 ...
