TUTA-GW2 user manual
（
Version:V1.4)
23
factory setting (clear of all users
’
setting), and resume to regular work status.
•
After the camera is reset, it will need to reset the
alarm number
. Refer to
chapter 3.2 Define alarm number.
%
Note
This function needs to be used carefully as it also erases the setting values.
Ì
Method
Method 1: Reset via the camera
•
Turn the power switch to
“
Off
”
position. It must remain off for a minimum of 20
seconds.
•
Turn on the camera, press and hold the reset key at the rear of camera for more
than 10 seconds.
•
Release the reset key when a
“
Beep
…”
tone can be heard, at the same time,
the indicator will light in green for 2 seconds, which means restoring factory
setting successfully. The indicator will restore to original status after resetting
the camera.
Method 2: Reset via SMS command
Any mobile phone sends following SMS command to camera in order to:
Reset the camera:
PSWD
reset
(20)
•
The
PSWD
is four digit numbers password.
•
For example
：
5678 reset
•
After receiving the command, camera will send out reminding message to
indicate resetting successfully.
Chapter 5 Advanced settings
5.1 Alarm settings
&
Description
The camera will enter auto-alarm mode and send notification messages to the
previously set
alarm number
or E-mail addresses once the built-in sensor is
detected.
Any mobile phone can send following commands to the camera to set alarm ways.
The
PSWD
on the command is four digit numbers password:
