www.cap-homey.com
User Manual
CAP-TECH INTERNATIONAL CO.,LTD.
If the device is online, directly perform steps 1-5, if the device is offline, need interruption of the
device power supply first, and then perform step 1-5.
DEVICE RESET
Reset procedure clears the modules’ EPROM memory, including all information about the Z-Wave
network controller, calibration and power consumption data.
1)
Make sure the device is connected to the power supply.
2)
Pressing link key 3 times within 1.5 second (The orange LED lights up and sends out "beep"
sound when link key is pressed.).
3)
Within 1 second, press and hold the link key about 5 seconds until the LED light turns off (A
long beep is sounded for 5 seconds and the LED light turns off).
4)
IDs are excluded and all of preset value will be reset to factory default (LED: 2-second on,
2-second off ; Beep sound: every 10 seconds, 0.1 seconds each ring).
Installation Instructions
It’s recommended to install the ALARM in dry indoor place.
DEVICE INSTALLATION
1)
Loosen and remove the screw at the bottom of the alarm, then slip he alarm back cover, the
back cover can be removed;(Fig. 1 & 2)
2)
Insert 4 LR14/1.5 V alkaline batteries to the battery compartment, ensuring correct polarity is
put (Fig.3).
Fig.1 Fig.2 Fig.3
