18
19
ASSEMBLY FROM THE BIKEGUARD
ASSEMBLY FROM THE BIKEGUARD
Fix the white reflector to the handlebars, the red
reflector to the seat post and the spoke reflectors
to the spokes.
Observe the road traffic regulations in
the country where you use the
Speedmax.
Especially with small frame sizes, there
is the risk of your foot colliding with the
front wheel. Therefore, be sure to use step‑in
pedals, if possible. In addition, make sure the
cleats are accurately adjusted.
The Di2 battery of the Canyon Speedmax is lo‑
cated in the lower third of the down tube. The
battery must be removed at Canyon only. Contact
our service hotline or use our contact form.
In the case of SRAM’s eTAP/AXS Road there is one
battery at the rear derailleur and another one at
the front derailleur. You find them together with
the charger in the cardboard box with the small
parts in your BikeGuard.
Remove the faceplate subsequently.
The Di2 battery is charged with a Shimano charg‑
er at the junction box.
To get access to the junction box you have to dis‑
mount the front wheel first. Loosen the bolt un‑
derneath the face plate by using a 3 mm‑Allen key.
Now you can connect the Di2 charger to the junc‑
tion box.
After having charged the battery, reposition the
faceplate and tighten the bolt to the prescribed
torque value of 1.5 Nm.
For more information read the chapter
“Shimano
Di2”
in your bicycle manual road bike or at
si.shimano.com
The electrical contacts of the battery are protect‑
ed with a red cover. Remove these covers from
the batteries.
SHIMANO Di2 BATTERY AND CHARGER
SRAM ETAP/AXS ROAD
Be sure to charge the battery only with
the battery charger supplied. Do not use
the charger from another manufacturer, even if
the plugs of the battery charger fit into your
rechargeable battery.
Keep the covers in a safe place to have
them at hand in case of a possible dis‑
patch or for a journey.
