40W267 Keslinger Road
PO BOX 393
LaFox, IL 60147-0393 USA
A Division of Richardson Electronics
Web
www.canvys.com |
Phone
888.735-7373 |
Fax
630.
208.2350
Rev. 2/09
Preface
About this manual
This manual is designed for use with the PC55002R Prosumer/Industrial display. Information in this document
has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The
information in this document is subject to change without notice.
Copyright
Copyright 2010
This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may
be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the
manufacturer.
Trademarks
All trademarks and registered trademarks are the property of their respective owners.
FCC compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions.
(1)
This device may not cause harmful interference, and
(2)
This device must accept any interference received, including interference that may cause undesired
operation.
Federal communications commission (FCC) statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
