31
GB
TROUBLESHOOTING
Height
difference
sensor
Note!
If the above actions do not resolve the problem, proceed as follows:
•
Reset the robot vacuum cleaner by switching it OFF and then ON using the power button on the bottom.
•
If the reset does not resolve the problem, send the robot vacuum cleaner to your dealer for repair.
Problem
Possible cause
ACTION
1
The robot vacuum cleaner suddenly
stops cleaning and the LED shows blue
The robot vacuum cleaner has
been picked up
Put the robot vacuum cleaner back on the floor and
restart it
2
The robot vacuum cleaner has started
and the LED shows blue
Height difference sensor fault
Clean the height difference sensor
If cleaning does not resolve the problem, send the
appliance to your dealer for repair
3
The robot vacuum cleaner does not
change direction when it encounters an
obstacle
Bumper sensor fault
Check that nothing is covering the sensor
4
The LED flashes red and a beep is
heard when the robot vacuum cleaner
is being charged
The power switch may be set to
OFF
Set the power switch to ON
5
The LED flashes red
Low battery charge
Fully charge the battery
6
The blue LED flashes once and the red
LED flashes once
A side brush has got caught
Place the robot vacuum cleaner on a flat surface and
clean the side brush
7
The blue LED flashes once and the red
LED flashes twice
The robot vacuum cleaner's
bumper is not flexible enough
Loosen the bottom screw on the bumper half a turn
8
The blue LED flashes once and the red
LED flashes three times
A wheel has jammed
Check the wheels (remove any foreign object)
