3
87
English
7
Connect the (slave) speaker you want to pair to the mains and – if applicable – switch this speaker on at the power switch. If the speaker is in stand
by mode, turn it on by pressing the power button on the remote control.
Caution:
The maximum time between pressing the OK button and turning on the slave speaker is 30 seconds.
8
Approx. 10 – 20 seconds after switching on the slave speaker the displays should show [CON] resp. "Connected" at the OSD.
9
If [FAI] appears in the display, repeat steps 4 – 7 and make sure that…
a.) the desired slave speaker was disconnected from the mains for at least 30 seconds.
b.) not more than 30 seconds have been passed between pressing the OK button and witching on the slave speaker.
c.) the distance between the two speakers (BRA 3 / VRA 3 and slave speaker) may not exceed 10 m and they are in the same room.
10
To pair a further speaker resp. a subwoofer, please repeat steps 4 – 7.
Caution:
Should you have performed the above steps, never repeat them with the BRA 3 / VRA 3 speaker switched off, as this will automatically
designate a new master speaker and would prevent the previous slave speakers from connecting to the previously designated BRA 3 / VRA 3.
Bluetooth Setup [BT]
At this menu you can set all features relating to the Bluetooth wireless technology module integrated into the BRA 3 / VRA 3. The Bluetooth
Setup menu includes four submenus, as follows:
Pair Mode [BTP]
This menu allows you to set whether the speaker sends a pairing request to mobile devices permanently (AUT) or whether this has to be
done manually [MAN] via the Bluetooth paring button on the remote control.
To change the way in which the paring process is initiated, proceed as follows:
1
To enter the menu, press the "M" button.
2
Use the
" "
or " " button to navigate into the menu Bluetooth Setup [BT] and confirm with the "OK" button.
2
Press the "OK" button and select the wanted parameter [MAN] resp. [AUT] using the "+" or "-" key
[AUT]= Device transmits pairing request permanently (automatic mode).
[MAN]= Request is activated by pressing the Bluetooth Pairing button on remote.
3
Then press the"OK" button, again.
