60
English
Problem
Possible cause
Solution
No playback via
Bluetooth
®
Wireless
Technology�
1� There is no connection between the loud-
speaker system and the mobile end device�
1� Connect your mobile end device as described�
2� The mobile end device is paired but
no playback takes place�
2�1� The mobile end device must be connected again�
2�2� Set the volume on the mobile end device to maximum�
2�3� Increase the volume of the loudspeaker system�
2�4� Make sure that possible interfering sources such as a
WLAN router or a laptop are not set up very close to the
loudspeaker system�
2�5� Simultaneous operation via WLAN and Bluetooth
®
connection from a mobile end device is not possible
without interference in most cases: therefore deactivate
the WLAN on the end device�
3� You are out of range� (max� 10 m)
3� Reduce the distance between the master loudspeaker and
the mobile end device�
The device does not
switch on automati-
cally from the optical
or coaxial input�
1� The preset (factory setting) for the AUT
function is OFF (disabled)�
1� Activate the AUT function (ON)�
2� The device was switched off using the “ON/
Standby” button of the Canton remote control
or the “Power” button of the TV remote
control (when using the IR learn function)�
2� Switch the loudspeaker system on using the “ON/Standby”
button of the Canton remote control and wait in future
until it switches automatically to standby mode�
3� The device was switched to the other digital
input which receives no signal and has switched
itself off automatically�
3� Switch the device on using the “Power” button of the
Canton remote control and select the digital input where
the desired source device is located�
Summary of Contents for C 500 Aktiv
Page 33: ...31 English C 5 0 0 A k t i v...
