Zodiac FR100
TM
Page 10 of 15
Installation Manual
June 2014 • Rev. 1.2
READER MOUNTING
1.
Do not install the mounting plate to the reader until the last step.
2.
Connect cables with terminal blocks through the gap of the mounting
plate as shown.
See Wiegand reader wiring section
.
3.
If necessary, connect an Ethernet cable (RJ-45) to the RJ-45 jack through
the gap of the mounting plate.
4.
If mounted as a standalone reader, use the supplied transformer and plug
the connector to the 12VDC port through the gap of the mounting plate.
5.
Install the mounting plate to the wall (1.15 to 1.20 m above the ground).
See mounting plate section above for more information
.
6.
Mount the reader to the mounting plate using the mounting holes and the
mounting studs and ensure it is rested steadily on the mounting plate.
7.
Tighten screws at the bottom of the mounting plate to the reader.
Mounting Hole
Anchor Holes
Screws
Tamper Switch
Terminal Blocks
RJ-45 Jack
12 VDC Input
Mounting Studs
NOTE
:
For standalone application
e
ither use plug-in transformer OR terminal block for
power input.
