Via Wireless Lock
Installation Manual
July 2018 • Rev. 1.3
Page
of
6
20
Install Door Lock
For use on doors 1
3
∕
8
”-2” (35mm-51mm) thick.
Tools required for new installation:
•
Phillips head screwdriver
•
2
1
∕
8
” (54mm) hole saw
•
5
∕
16
” (8mm) drill bit
•
Chisel
Tools required for replacement:
•
Phillips head screwdriver
•
3
∕
8
” (9.5mm) drill bit
•
1” (25.4mm) drill bit
•
3
∕
4
” (19mm) drill bit
Follow all steps for new installation.
Follow steps 3c, 4c, 5 - 18 for replacement
installation after removal of old lock and latch.
1. MARK DOOR
2. DRILL HOLES
a. Start 38” from floor and mark
center of door edge.
b. Select backset 2
3
∕
8
” or 2
3
∕
4
” and
mark hole center on door face.
NOTE:
BACKSET ON DOOR FACE
MUST BE SAME AS
BACKSET OF YOUR LOCK.
c. Mark two holes for screw post.
Drill holes as marked.
NOTE:
DRILL 2
1
∕
8
” (54mm)
HOLE FROM BOTH
SIDES TO AVOID
SPLITTING WOOD.
3. INSTALL LATCH
4. INSTALL STRIKE
a. Insert latch in hole and keep it parallel to door
face. Mark outline and remove latch.
b. Chisel
11
∕
64
” (4-4.3mm) deep or until faceplate
flush with door edge.
c. Insert latch and tighten screws.
NOTE:
LATCH BOLT BEVEL MUST FACE TO CLOSING
DIRECTION.
a. Close door to mark horizontal line of strike.
b. Measure one half of door thickness from door stop to
mark vertical center line of strike. Drill 1” (25.4mm)
hole,
1
∕
2
” (12.7mm) deep at intersection of horizontal
and vertical center lines.
c. Cut out jamb
3
∕
32
” (2.4mm) deep or until strike flush
with jamb. Tighten screws securely.
a b c
a b c
