CanLan
Page 13 of 31
Installation Manual
August 2014 • Rev. 1.2
8.
If LED B is off, first power the CanLan off and on again, and then make
your selection (as above).
9.
Press
OK
.
10.
Once a connection is established, the configuration software will retrieve
the current data from the CanLan.
11.
The red connection icon at the bottom of the configuration software
window will change to green and the message
Unit Online
will be
displayed. LED B will stay on until
Quit
is pressed.
Troubleshooting Tips
If a connection cannot be established, the connection icon will remain red
and the status line will report Unit Offline.
Verify the CanLan Connection
If you are using a network connection, go to
Start >Run
and type
cmd
and click
OK
to launch the Windows
®
command prompt. Type
ping
10.0.0.100
and then hit the
Enter
key on your keyboard. If there is no
reply, double-check the cable connection and/or IP settings.
Try a Serial Connection
If successive attempts to establish a network connection are unsuccessful,
try using a serial connection instead.
For more troubleshooting tips, see the
Troubleshooting a Connection
section
at the end of this manual.
Summary of Contents for Canlan
Page 1: ...Canlan INSTALLATION MANUAL August 2014...
Page 2: ......
