WUX500ST (18/18)
reduce luminance owing to the characteristics and extensive use of the mercury lamp.
Prolonged usage may also lead to breakage of the lamp. Contact a local dealer for
service and replacement of the lamp; such maintenance should be conducted at a
service center by a qualified personnel.
Note: The chance of lamp breaking before its replacement period is less than half and it is likely that the lamp
will not break until the end. However the actual time until breakage will vary extensively by each lamp.
The reason for such individual variability is minute manufacturing defect is suspected however accurate time to
breakage cannot be estimated to date.
●
Set the Fan Control mode (High altitude mode) to ON when using the projector in high
altitudes (2,300 meters or more above sea level) where the atmospheric pressure is
low
●
Use of a cable capable of transmitting EDID data is recommended when inputting
analog PC signal: Video signal incompatible with the projector may be outputted from
the source device if the source device cannot read the EDID data from the projector. In
such case, replace the cable with an EDID-data transmittable cable or change the dot
clock of projector-compatible signal to below 162 MHz in the output source device.
●
Video and audio using NMPJ: The following phenomenon may generate depending on
the characteristics of a computer or network in use. This is not a projector malfunction:
w
Image is not reproduced smooth and natural
w
Irregular gap will generated in the video and audio
