12
Use the Battery Pack BP-511A, 514, 511, or 512 for powering the transmitter. When replacing
the transmitter’s battery, be sure to first set the camera’s power switch to <
OFF
> before opening the
transmitter’s battery compartment cover. In particular, if the transmitter’s battery compartment
cover is opened without setting the camera’s power switch to <
OFF
> when an external media or a
GPS device is connected, the connection operation for the external media or GPS device will have
to be performed again.
The transmitter’s battery is not included. Customers who do not have one should purchase it
separately.
1
Open the cover.
Slide the lever to open the cover.
2
Load the battery.
Insert from the side with battery contacts.
Insert the battery all the way until it locks into
place.
3
Close the cover.
Press the cover up until it clicks into place.
The remaining battery power is displayed when the camera’s power switch is set to <
ON
>.
z
:
The battery has enough power.
x
: The battery power is low.
n
: The battery must be recharged.
Loading and Unloading the Battery
Loading
Battery check
COP
Y
Summary of Contents for WFT-E3
