2-25
Step 4 Install the Camera
Init
ial S
e
tting and
Ins
ta
llati
o
n
of Cam
e
ra
Focus Adjustment Method
To adjust the focus, press the reset switch to enter the installation mode. Accurate focus
adjustment can be performed in the installation mode. Also note that video output is enabled
in the installation mode.
Procedure
• So you can check the camera image, connect a monitor to the video output or
otherwise display image on the PC via a LAN. See Step 3: "Check the Video Captured
• Next, press the reset switch and adjust the focus.
• Once the focus has been adjusted, turn off the power and then turn it back on, or
reboot the camera from the setting page, to end the installation mode.
Take note that the installation mode ends automatically after 30 minutes. If you want to
continue with the focus adjustment, press the reset switch again.
Note
When the lens is used in the telephoto mode, focus change may become conspicuous if the
dome case is installed. In this case, you can prevent out-of-focus by adjusting the focus to a
point closer than the target subject.
Tip
Image from the network is disconnected when you switch to the installation mode (when the
reset switch is pressed) or return to a normal mode from the installation mode.
In the installation mode, the camera cannot be controlled.
Only NTSC is supported for video output.
The LED remains lit in the installation mode, and a white square is shown on the bottom left
of the screen.
Summary of Contents for VB-C500VD
Page 18: ...xviii Safety Precautions...
