Canon UJ122x8.2B AF, Operation Manual

Page: 8 / 22

BT1-D005-A-ENG ©2022.04 CANON INC. 6/20
Setting - <Setting> - I-Gain
1. Setting auto iris gain
Setting screen
I G : 5 0
<Setting>
I-Gain:
RBF:
System
50
000
I G : 5 0
<Setting>
I-Gain:
RBF:
System
50
000
to adjust
Note
• When adjusting gain while checking iris operation, set the camera iris mode to [AUTO].
• Set so that maximum gain is obtained within the range where focus hunting does not
occur.
• The iris gain setting is not reset if settings are reset as described on page 1.
Selection item 01 – 99
Function Minimum gain Maximum gain
Default value: 50
Setting - <Setting>
Lens setting menus
A variety of lens settings are available.
Setting screen
I G : 5 0
<Setting>
I-Gain:
System
AF
Zoom
Focus
Iris
IS
Reset All
1
2
3
4
5
6
7
8
9
RBF: 000
50
1. I-Gain: Setting auto iris gain
2. RBF: Setting remote back focus (RBF models only)
3. System Accessing the System screen
3.1 Indicator: Setting the indicator on/off
3.2 Tally: Setting the tally function on/off
3.3 Cafs: Setting the CAFS
3.4 VR-Out: Setting virtual output
3.5 CamSeri: Enabling/disabling camera serial
communication
3.6 TalBrtness: Setting tally brightness
3.7 LensCode: Setting the lens code
4. AF Accessing the AF screen ( AF models only)
4.1 Steps: Setting the number of steps for AF frame
movement
4.2 MoveSpeed: Setting AF frame speed
4.3 Accessing the Size screen
4.3.1 Horz: Horizontal AF frame size setting
Vert: Vertical AF frame size setting
4.3.2 ResetSize: Restoring default AF frame settings
5. Zoom Accessing the Zoom screen
5.1 Movement: Setting zoom servo start characteristics
Setting zoom servo stop characteristics
Setting zoom mechanism end stop
characteristics
5.2 PreMovement: Setting zoom start characteristics
for preset operations
Setting zoom stop characteristics
for preset operations
5.3 CurveMode: Setting analog demand curve
characteristics
5.4 CamMode: Cam mode setting
5.5 Control: Setting the servo mode from the zoom demand
6. Focus Accessing the Focus screen
6.1 Curve: Setting focus demand curve characteristics
7. Iris Accessing the Iris screen
7.1 [I-Gain]: Setting auto iris gain
Setting remote iris gain
7.2 Comp: Setting iris compensation on/off
7.3 Close: Setting iris closure detection on/off
8. IS Accessing the IS screen ( IS models only)
8.1 Mech.Lock: IS mechanical lock setting
8.2 SwSetting: IS operation switch setting
8.3 OffState: IS mode setting
9. Reset All Resetting to defaults
Setting