32
Others
• When using a UV lamp frequently, take extra care about paper
shrinking due to heat (in the feeding/sub-feeding (paper width)
directions), or about color fogging.
• The paper surface is slippery. Apply slightly stronger drive roller
pressing force.
• If you want a higher PCS value for the mark for position detection,
perform overprinting.
• Depending on the type of preprinted paper, sticking, etc. may
occur. Make sure to evaluate such phenomena using the printer
that you actually use.
A
Press and hold the Power Button to turn OFF the power.
B
Press the Power Button while pressing the Feed Button to
turn ON the power.
The test print starts. The test print is performed repeatedly until
you stop it.
C
Press the Feed Button to stop the test print.
NOTE
The test print stops if a printer error such as “Paper End” or “Paper Cover
Open” etc. occurs. Once the error is cleared, the test print resumes.
Test Print
a. 50% checkered pattern printed
(2 lines)
b. 25% checkered pattern printed
(3 lines)
c. Status of the internal settings printed
The statuses of the interface settings
and other advanced settings are
printed.
d. Japanese character set (12 x 24)
(a complete set)
e. Standard character set (12 x 24)
(a complete set)
f. International character set (12 x 24)
(a complete set)
g. Japanese character set (08 x 16)
(a complete set)
h. Standard character set (08 x 16)
(a complete set)
i. International character set (08 x 16)
(14 lines)
j. Kanji (24 x 24) (15 lines)
k. 100-dot feed, partially cut
l. 160-dot feed, fully cut
