paper path;
remove foreign material.
(3) Cable connection
(4) Part replacement:
- EJ slit disk film
- LF / EJ timing sensor unit
- Platen unit
- Logic board
- Paper feed motor
18 times
Spur base lift
mechanism
error
[5120]
The spur base did not
move up or down
properly.
(1) Cable connection
(2) Part replacement:
- ASF unit
- Spur base lift unit
- Logic board
19 times
Ink tank
position
sensor error
[6502]
None of the ink tank
position is detected.
(1) Ink tank position;
confirm the ink tank position.
(2) Re-set or replacement of ink tanks
(3) Cable connection
(4) Part replacement:
- Ink tank position sensor error
- Logic board
20 times
Other errors [6500]
An unidentified error or a
network error occurred.
(1) Part replacement:
- Logic board
Before replacement of the logic board ass'y, check the ink absorber counter value (by
service test print or EEPROM information print). If the counter value is 7% or more,
also replace the ink absorber kit when replacing the logic board ass'y. If the counter
value is less than 7%, register the current ink absorber counter value to the replaced new
logic board instead. [See
4-4. Special Notes on Servicing, (5) Ink absorber counter
setting
, for details.]
16 / 56
