Canon PIXMA MP510, Service Manual

Page: 10 / 68

2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green (Power LED), or
Both LEDs Lit)
Service call errors are indicated by the number of cycles the Alarm LED and Power LED blink, and the corresponding error code is
displayed on the LCD.
- Fill in all the circles on the print head
alignment sheet.
- Place the sheet in the correct orientation and
position.
The remaining ink amount
unknown.
[1683]
(Applicable ink tank icon)
The remaining level of the following ink
cannot be correctly detected. Replace the ink
tank. (U130)
An ink tank which has once been empty is
installed. Replace the applicable ink tank with
a new one.
Printing with a once-empty ink tank can
damage the printer.
To continue printing without replacing the ink
tank(s), press the OK button for 5 sec. or
longer to disable the function to detect the
remaining ink amount. After the operation, it is
recorded in the printer EEPROM that the
function to detect the remaining ink amount
was disabled.
Ink tank not recognized. [1684]
The following ink tank cannot be recognized.
(U140)
(Applicable ink tank icon)
A non-supported ink tank is installed (the ink
tank LED is turned off). Install the supported
ink tanks.
Ink tank not recognized.
[1410 to
1419] The following ink tank cannot be recognized.
(U150)
(Applicable ink tank icon)
A hardware error occurred in an ink tank (the
ink tank LED is turned off). Replace the ink
tank(s).
Scanning unit (printer
cover) open.
[1200] Cover is open. Close cover.
Close the scanning unit (printer cover).
Cycles of blinking
in orange (Alarm
LED) and green
(Power LED)
Error
Error
code
Conditions
Solution
(Replacement of listed parts, which
are likely to be faulty)
2 times Carriage error [5100] An error occurred in the carriage encoder signal. - Carriage unit (QM2-3753)
- Timing slit film (QC1-9542)
- Logic board (QM2-3827)
- Carriage motor (QM2-3872)
3 times Line feed error [6000] An error occurred in the LF encoder signal. - Timing sensor unit (QM2-3878)
- Timing slit disk film (QC1-9597)
- Feed roller (QL2-1407)
- Logic board (QM2-3827)
- Paper feed motor (QM2-3873)
4 times Purge cam
sensor error [5C00] An error occurred in the purge unit. - Purge unit (QM2-3754)
- Logic board (QM2-3827)
5 times ASF (cam)
sensor error
[5700]
This error takes place when feeding paper from the
ASF after an error occurred in the ASF cam sensor. - Sheet feed unit (QM2-3762)
- ASF_PE sensor board (QM2-3877)
- Logic board (QM2-3827)
6 times Internal
temperature
error [5400] The internal temperature is not proper.
- Logic board (QM2-3827)
- Carriage unit (QM2-3753)
7 times Ink absorber
full [5B00,
5B10,
5B01,
5B11]
The ink absorber is full.
Error codes:
Overseas:
5B00: Main ink absorber
5B10: Borderless-print ink absorber
Japan:
5B01: Main ink absorber
- Ink absorber kit (QY5-0178)
1-5