Canon PC-D320, Service Manual

Page: 99 / 214

PC-D320/PC-D340/FAX-L400 Chapter 4: Maintenance and Service
4-19
No. Tx or Rx Definition
##0290 [TX ] After transmitting MPS, a signal other than PIN, PIP,MCF,
RTP, or RTN was received
##0295 [TX ] For the auto alarm notification function, the other party does not
have an NTT remote maintenance function
##0670 [TX ] In V.8 late start, the V.8 ability was detected in DIS from the
other party and, in response, CI was transmitted; however, the
procedure failed to advance, causing a T1 time-over condition
##0671 [RX ] In V.8 call arrives, the procedure fails to advance to phase 2 after
CM detection, causing a T1 time-over condition
##0672 [TX ] In V.34 transmission, the procedure fails to move from phase 2
to phase 3 and later, causing a T1 time-over condition
##0673 [RX ] In V.34 reception, the procedure fails to move from phase 2 to
phase 3 and later, causing a T1 time-over condition
##0674 [TX ] In V.34 transmission, the procedure fails to move from phase 3
or phase 4 to a control channel or later, causing a T1 time-over
condition
##0675 [RX ] In V.34 reception, the procedure fails to move from phase 3 or
phase 4 to a control channel or later, causing a T1 time-over
condition
##0705 [TX ] In CHT transmission, DCN was received after detecting NACK
##0711 [TX ] In CHT transmission, REJ was received after transmission of an
image signal
##0750 [TX ] In ECM transmission, no significant signal can be received after
transmission of PPS-NULL, and the allowed number of
procedure signal re-transmissions was exceeded
##0751 [TX ] In ECM transmission, a signal other than MCF, PPR, or RNR
was received after transmission of PPS-NULL
##0752 [TX ] In ECM transmission, DCN was received after transmission of
PPS-NULL
##0753 [TX ] In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded or a T5 time-over (60 sec)
condition occurred after transmission of PPS-NULL
##0754 [TX ] In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded after transmission of PPS-NULL
##0755 [TX ] In ECM transmission, no significant signal can be received after
transmission of PPS-MPS, and the allowed number of procedure
signal re-transmissions was exceeded
##0757 [TX ] In ECM transmission, DCN was received after transmission of
PPS-MPS
##0758 [TX ] In ECM transmission, the allowed number of procedure signal
re-transmissions was exceeded or a T5 time-over (60 sec)
condition occurred after transmission of PPS-MPS