35
Turning off the Projector
To turn off the projector:
3. Projecting an Image (Basic Operation)
1. Press the POWER (
) button on the projector cabinet or the
remote control. The “Push POWER button again to turn off
power. /Carbon savings-Session 23.220(g-CO2)” message
will appear. See page
. Amount of carbon emission reduc-
tion will be displayed only when [Lamp mode] is set to [Quiet].
When [Lamp mode] is set to [Normal], the amount of carbon
emission reduction will be displayed as “00.000 (g-CO2)”.
Power On
Standby
Steady
green light
Steady
orange light
CAUTION:
Parts of the projector will become heated during operation. Use
caution when picking up the projector immediately after it has
been operating.
CAUTION:
• The projector cannot be turned off for 60 seconds after the
lamp is turned on and while the POWER indicator is blinking
green. Doing so could cause premature lamp failure.
2. Press the POWER button again.
The projector turns off and goes into standby mode.
When in standby mode, the POWER indicator will light or-
ange (the cooling fans stop at the same time) and the STA-
TUS indicator will light green.
3. Turn off the Main Power switch. The POWER indicator will go
out.
The projector has a feature called“Direct Power Off”. This
feature allows the projector to be turned off (even when
projecting an image) by using the Main Power Switch or dis-
connecting the AC power supply. To turn off the AC power
supply when the projector is powered on, use the Main
Power Switch, or a power strip equipped with a switch and a
breaker.
NOTE: Do not turn off the main power within 10 seconds of making adjust-
ment or setting changes and closing the menu.
Doing so can cause loss of adjustments and settings.
BLANK
MENU
POWER
INPUT
IMAGE
ASPECT
INFO.
AUTO PC
