Canon LK-62, User Manual

Page: 8 / 152

8
Battery Attachment
The battery attachment is the case used to load the
battery pack and connect it to the printer.
* Certain models may not be available in some
countries or regions.
* This battery attachment is for iP110 series/
iP100 series and supplied with LK-62, iP110 with
battery and iP100 with battery.
(1) Charge lamp
The lamp stays on, turns off or flashes to indicate
the battery charging progress and battery
condition. When an error occurs, the lamp
flashes.
For the battery charging progress, see “Charging
the Battery”.
For the battery condition and errors, see
“Troubleshooting”.
Attaching the Battery to the
Printer
When using the printer in locations where there is no
power outlet (outdoors, etc.), attach the battery (i.e.
battery pack installed in the battery attachment) to
the printer. Before using the battery pack and battery
attachment, read “Safety Precautions” thoroughly.
1
Turn off the printer and disconnect the
AC adapter and USB cable from the
printer.
2
Take out the battery pack of the package
and load it in the battery attachment.
Load the battery pack in the battery attachment
with the printer connector facing upward, and
then push down on the battery pack until it clicks.
Printer connector
Directions for Use
• The battery pack is not charged when it is
purchased. Please charge it before use.
• The operating temperature range of the
battery pack is from 5°C to 35°C/41°F to 95°F
(condensation should not occur with a sudden
change in the temperature). If the battery
pack is used outside this range, the following
problems could occur:
- The battery pack cannot be charged.
- The time required to charge the battery
pack fully becomes longer.
- The number of pages printed per charge is
much reduced.
- The printer cannot be used.
If one of the above problems occurs, move the
battery pack to the place where the ambient
temperature is normal.
• During use, the battery may become warm.
This is not a problem.
• The battery pack is a consumable product.
If the fully charged battery pack becomes
exhausted quickly, please purchase a new kit.
Directions for Storage
• If the battery pack is not used for a long
period of time (6 months or longer), remove
the battery from the printer and store them
separately.
• Store the battery pack in a cool, well-
ventilated place. Storing the battery pack in
the following places may reduce its life or
cause a failure:
- In a place exposed to direct sunlight
- In a place exposed to heat, for example,
near a heater
- In a hot place, for example, in a car
- In a dusty or damp place
Directions for Disposal
Dispose of used batteries according to the local
regulations.
Parts and Functions
LK-62 contains a battery pack and a battery
attachment. See below for details.
Battery Pack LB-60
This is a lithium-ion battery. To use the battery, load
the battery pack in the battery attachment.
Printer connector
LK-62_UG_MLT_body.indd 8 2014/06/23 15:25:28