Canon Laser Shot LBP5970, User Manual

Page: 454 / 550

7-59
Tr
oub
leshooting
7
When You Cannot Obtain Appropriate Printout Results
Remedy 2 Perform a soft reset using the RESET menu, then print again with the resolution
level being lowered.
Remedy 3 If you want to print in the Super Fine mode, perform a soft reset by pressing
[Reset], and then increase the free space of RAM using the following
procedure.
- Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory that the printer has received will be deleted).
- Install an optional expansion RAM module. (See Getting Started Guide)
A portion of a page is not printed.
Cause 1 The scale factor is incorrect.
Remedy 1 Clear the [Manual Scaling] check box in the printer driver. If the check box is
cleared, the scale factor will be set according to [Page Size] and [Output Size]
automatically.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.
Remedy 2 Select the [Manual Scaling] check box in the printer driver, then specify an
appropriate scale factor according to the paper size to be used.
In order to specify the setting for [Manual Scaling], display the [Page Setup]
sheet.
Cause 2 The position of the paper is incorrect.
Remedy Load the paper properly. (See "Loading Paper in Cassette 1," on p. 3-20,
"Loading Paper (Other than Envelopes)," on p. 3-49)
Cause 3 A document with no margins was printed.
Remedy 1 The printable area of this printer is as follows (10 mm for envelopes if you are
using the UFR II/PCL printer driver). Secure a margin around the data.
When the UFR II printer driver is used: The area except for 5 mm of the edges
of paper
When the PCL printer driver is used: The area except for 4.23 mm of the
edges of paper
When the PS printer driver is used: The area except for 4 mm of the edges
of paper