Canon Inner Finisher-K1, Service Manual

Page: 76 / 114

No Items Outline Use case
[7] SORTER > OPTION > TRY-PSTN To set the tray position after the com-
pletion of job Upon user's request (to improve
visibility of the delivered paper)
[8] SORTER > OPTION > PADL-TM *2 To set whether to extend paper pull-
back time at 2-sided print.
*2: This item is displayed in Lv.2 when
connecting to iR-ADV devices. When paper pull-back failure oc-
curs at high-density full-color 2-
sided printing
[9] SORTER > OPTION > EXEC-SFT To set the EXEC front stapling shift
operation In a high temperature and high
humidity environment, EXEC
cotton bond paper may curl in the
feed direction. Use this mode if
you execute a front stapling job in
this environment and alignment
errors occur.
Basic Adjustment Items
N
o
Items Use case Refer to
1 Adjusting Stacker Alignment Position When misalignment occurs in front/rear direction.
“Adjusting Stacker
Alignment Position ” on
page 73
2
Adjusting Center Alignment Standard
Position
• When the standard position for the center alignment is
misaligned.
• When misalignment occurs in front/rear direction.
“Adjusting Center Align-
ment Standard Position ”
on page 77
3
Right Angle Adjustment of Alignment
Plate • When remove or replace the alignment plate.
• When the paper alignment position is displaced.
“Right Angle Adjustment
of Alignment Plate ” on
page 71
4 Adjusting the Return Belt Pressure When misalignment occurs in feed direction.
“ Adjusting the Return
Belt Pressure” on page
80
5 Adjusting the Staple Position
When the staple position in front/rear direction is displaced in
the front/rear 1-stapling mode or 2-stapling mode. “Adjusting the Staple
Position ” on page 81
6
Adjusting the Stapler Unit Installation
Position
• When the stapler unit is replaced.
• When the staple position in feed direction is displaced in
the front/rear 1-stapling mode or 2-stapling mode.
“Adjusting the Stapler
Unit Installation Posi-
tion ” on page 82
7
Adjusting the Staple-Free Binding Posi-
tion When the staple-free binding position in the staple-free binding
mode.
“Adjusting the Staple-
Free Binding Position ”
on page 84
Adjustment Items When Replacing Parts
No Target part Adjustment item and description Reference
1 Finisher Controller PCB
Backup operation before replacement and operation
after replacement
“Handling Finisher Controller
PCB Replacements” on page
86
5. Adjustment
70