Basic Adjustment
Alignment Plate Right-Angle Adjustment
When you remove or replace the alignment plate of the processing tray unit or when alignment errors occur, adjust the right-angle
of the alignment plate.
■ Right Angle Adjustment of Alignment Plate
<Use case>
• When remove or replace the alignment plate.
• When the paper alignment position is displaced.
Feed Direction
Feed Direction
<Procedure of adjustment>
CAUTION:
Perform the adjustment under either of the following states.
• The processing tray unit is stable with the bases such as paper stack.
• The processing tray is set in the inner finisher. However, remove the upper feed guide unit to access the screw for
adjustment.
1. Place A4 or LTR paper on the processing tray unit, and push it against the stopper.
Paper
Stopper
Stopper
5. Adjustment
71
Summary of Contents for Inner Finisher-K1
