Canon imagePROGRAF iPF825 MFP Basic Guide No.1, User Manual, Page: 889 / 956

Cannot print over a network
Cannot connect the printer to the network ......................................................................................................
873
Cannot print over a TCP/IP network ................................................................................................................
873
Cannot print over a NetWare network .............................................................................................................
874
Cannot print over AppleTalk or Bonjour networks ...........................................................................................
874
Cannot connect the printer to the network
Cause Corrective Action
The Ethernet cable
is not connected
correctly to the
printer's Ethernet
port. 1.
Make sure the printer is connected to the network with the correct Ethernet cable, and then
turn the printer on. For instructions on connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100 Base-TX and orange if connec-
ted via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the hub is on.
•
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
• Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
• Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate
automatically (in auto negotiation mode), sometimes the hub settings cannot be detected.
In this case, configure the connection method manually, specifying the communication
mode in use.
(See " Configuring the Communication Mode Manually .")
→P.776
Cannot print over a TCP/IP network
Cause Corrective Action
The printer's IP address is not
configured correctly. Make sure the printer's IP address is configured correctly.
(See " Configuring the IP Address Using imagePROGRAF Device Setup Utili-
ty .")
→P.410
(See " Configuring the IP Address Using the Printer Control Panel .")
→P.770
The printer's TCP/IP network set-
tings are not configured correctly. Make sure the printer's TCP/IP network settings are configured correctly.
(See " Configuring the Printer's TCP/IP Network Settings .")
→P.773
The computer you are trying to
print from is not configured cor-
rectly. Make sure the computer's TCP/IP network settings are configured correctly.
(See " Configuring the Printer Driver Destination .")
→P.779
(See " Configuring the Destination for TCP/IP Network .")
→P.793
Troubleshooting > Cannot print over a network >
iPF825 Cannot connect the printer to the network
12
873