4-16
SmartBase MPC200/imageCLASS MPC200
Chapter 4: Maintenance & Service
d) New error codes and recovery methods
Those error codes that have been added starting with the product and those error codes for which
remedies unique to the product are offered are shown together with causes and remedies, where
applicable.
##343 Ink absorber for ink detection has become full
Solution:
Unlike errors that trigger the
“CHECK PRINTER”
message, This error is
programmed so that it cannot be cleared using the
Resume
button. Replace the
waste ink absorber as follows in the error occurs:
(1) Select
5. INK ABS CAPA
under
#7 PRINTER
in service mode, and the
counter to 0.
(2) Check to make sure that no image exist in memory; then, turn off the power,
remove the appropriate parts, and replace the waste ink absorber.
##352 Printer control EEPROM head information error
Cause:
The EEPROM for printer control is faulty.
Solution:
(1) Turn off and then on the power.
(2) Turn off the power, and replace the print head.
(3) Replace the SPCNT board.
In the presence of ##352, the carriage unit will not move to head replacement position
even when the inner cover is opened. Moreover the carriage will not be locked in
position even when the power is turned off.
When replacing the head, be sure to turn off the power, and draw out the carriage before
replacement.
NOTE
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com
