3-9
SmartBase MPC200/imageCLASS MPC200
Chapter 3: Assembly and Disassembly
Caution When Replacing SPCNT Board
To replace the SPCNT board, perform the following:
a) Caution before replacing
You will need to execute 'all clear' at the end of replacement. As necessary, print out the
following data:
a-1) Image Data in Image Memory
The image data stored in image memory will be lost when the power is turned off.
Before turning off the power, check to make sure that all images have been printed
out.
a-2) Data on the Amount of Waste Ink in the Absorbent and the Print Position
Adjustment Data
The EEPROM on the SPCNT board is used to remember the amount of waste ink
collected by the absorbent and print position adjustment data. Be sure to replace the
waste ink absorbent at the same time whenever you are replacing the SPCNT board.
After replacement of the board, be sure also to enter '0' as the amount of waste water in
the new waste ink absorbent and adjust the print position.
a-3) Service reports
Select service mode, and select 'SERVICE REPORTS' using the
</>
button. Press the
OK
button; then, select the type of list to generate using the
</>
button.
b) Replacing the SPCNT Board
(1) Remove the existing board.
(2) To prevent exhaustion of the battery otherwise occurring in storage, the jumper
plug (JP3) of the service SPCNT board (if new) is not shorted. Be sure to short the
plug before use.
(3) Mount the new SPCNT board, and put back all parts you may have removed.
(4) Turn on the power, and execute 'all clear'. For details, see the instructions to follow
in response to an error (See this Chapter 1.4 Action in the Event of Abnormality (All
Clear)).
(5) After executing 'All Clear', enter the data you have previously printed out as
necessary (battery backup).
NOTE
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com
