6-6 Self-timer indicator:
Red-eye reduction lamp (Blinks at 2 Hz for first 8 sec.,
then lights for the remaining 2 sec.).
LCD panel (Frame counter counts down from 10 to 1 in
seconds)
Beeper (Beeping at 2 Hz for first 8 sec., then at 8 Hz for
the remaining 2 sec.).
* Beeper sounds only when enabled with the Func. setting.
6-7 Camera shake warning:
Provided in Full Auto and Programmed Image Control
modes.
* If the shutter speed (Tv auto) is slower than 0.5 stop below the
reciprocal of the lens focal length, the shutter speed display blinks at
2 Hz as a warning.
7.
Film Transport
7-1 Film loading:
Automatic take-up with a sprocketless system.
* After the film leader is set properly and the back is closed, the film
advances to frame 1 automatically (as displayed on the frame
counter), taking about 1 sec.
7-2 Film advance system:
Automatic film advance with a small coreless motor.
* Film perforation detected with an infrared photo reflector.
* Not compatible with infrared film.
7-3 Film advance modes:
(1) Single-frame shooting (2) Continuous shooting
(3) Self-timer/Remote control
* In Full Auto and Programmed Image Control modes: Set
automatically.
* In Creative Zone modes: Set manually with film advance lever.
7-4 Film advance initiation:
Exposure-completed signal starts film advance.
7-5 Continuous shooting speed :
Approx. 4 fps (in One-Shot AF mode, Tv = 1/250 sec. or
(max.)
faster, new batteries, 20 C)
* In AI Servo AF mode: Approx. 3.5 fps
7-6 Film advance indicator:
The frame counter counts up.
7-7 Battery service life:
The table below shows the number of 24-ex. rolls that
can be exposed with two new CR123A batteries and EF
50mm f/1.4 USM. Figures for when Eye Control is used
or not are also provided.
* The testing conditions are detailed in item 14-1.
7-8 Film rewind system:
Automatic rewind with a small coreless motor.
7-9 Film rewind initiation:
(1) Automatic rewind
Rewind initiated automatically under the following conditions:
1. Detection of end of film roll (no more film).
2. After 36 exposures are taken.
(2) Midroll film rewind
Midroll rewind button starts film rewind.
* During film rewind, pressing the midroll rewind button switches the
rewind mode between silent and high-speed rewind.
* For both (1) and (2), C.Fn-1-1 sets high-speed rewind.
Part 1: General Information
1-21
At 20ºC
At -20ºC
AE 100%, FA 0%
115 (125)
65 (70)
AE 50%, FA 50%
33 (38)
19 (20)
AE 0%, FA 100%
17 (19)
9 (10)
Shooting Conditions
Ambient
Temperature
Summary of Contents for EOS EOS 7
