CANNY 7 Demo Kit. Quick Start Guide.
1
Description
The CANNY 7 Demo Kit designed to power, control, test and demonstrate IO features of
CANNY 7 programmable logic controller.
What can you do with CANNY 7 Demo Kit:
-
upload the firmware and functional diagrams to the controller;
-
run the controller with loaded firmware in operating mode;
-
fast switching between operating mode and firmware uploading mode without cable
reconnecting;
-
power the controller from a standard PC's USB port through built-in CANNY 7 Demo Board's
5V-to-12V converter or by external power source connected to EXT1 port;
-
control the status of the controller's IO channels using the built-in LEDs: the brightness of the
LED shows the current on the IO channel and the color indicates the polarity of the signal,
-
imitation of external input signals using press-buttons allows to send signals of positive or
negative polarity to corresponding IO controller's channels.
2
Safety notes
Do not allow interaction of moisture and metal objects with the elements and surfaces
of the boards. If not, electric shock, short circuit or abnormal operation may occur.
Prevent static spark discharge, use grounding devices.
Do not connect the Demo Kit to the external circuits with voltages higher than 18V.
Improper use may cause permanent damage to the CANNY 7 Demo Kit and/or to
connected devices.
3
Demo Kit components
Programmable logic controller CANNY 7 included in CANNY 7 Demo Kit, comes with modified
external connectors, compatible with CANNY 7 Demo Board's socket.
Set of original CANNY 7 connectors, comes with CANNY 7 Demo Kit, allows user to bring
CANNY 7 controller to basic appearance by replacing mounted connectors (soldering needed!) and
putting in an included plastic enclosure.
Connector cables set allows to connect demo board or controller to external actuating and
signaling devices.
Interface cables USB-A/miniUSB are intended to connect demo board and attached controller,
allowing to load user programs to controller's memory, and also to provide powering of controller
during testing by connecting demo board to USB port of PC.
1
Rev.08122017
