18
137377 Rev 1.
English
SuperSix EVO Neo - Owner’s Manual Supplement
Removing the internal battery
The internal battery must only be service by a
professional bike mechanic.
1. Disassemble the headset cap so that
the fork may be lowered slightly within
the headtube. This is required to enable
adequate cable slack.
2. Remove the two screws and open the
down tube cable housing guide on the
downtube, to enable cable slack.
3. Remove the screws that retain the top
tube mounted iWoc® ONE.
4. Remove the bottom bracket cover and
chainstay cable guard.
5. Remove the four screws and open the
charge port from the frame opening.
6. Pull the upper cables wire thru the cable
guide hole in the DT and unplug the
connections.
7. Remove the crankset and remove the BB
shell.
8. Remove the rear wheel
9. Unplug the drive unit.
10. Open the charger plug
11. Pull the derailleur housing up thru the
charger plug hole to free the space for
the battery
12. Pull the battery down and out of the
downtube.
4
3
1
1
Front Derailleur Mount
(Mechanical shift shown)
The front derailleur mount is bonded to the frame.
It is a “braze-on type.”
Do not attempt to remove the mount.
When using a mechanical FD system or SRAM
Etap, make sure the frame plug is installed to
prevent the intrusion of water or debris into the
frame.
When using Di2 Systems, use the Di2 Cable Plug.
Summary of Contents for SuperSix EVO Neo
Page 35: ......
