18
Lefty Ocho 120 Owner’s Manual
138227 Rev 1 01/21)
Technical Information
Remote Lockout Setup
Remote Lockout Setup
1.
Cut a length of 4mm derailleur housing (1) to
extend between the handlebar lockout remote
lever and remote housing (2) stop. Install an
inline barrel adjuster 20-30mm from the lever
end.
2.
Set handlebar lockout remote to Descend
mode.
3.
Remove compression knob screw (9) and lift
off the compression knob (8) to expose the
lockout pulley (3).
4.
At the lockout lever, feed the shift cable (4) end
through to the remote housing. Pull the cable
tight to seat the housing in the housing stop.
5.
Loosen anchor bolt (5) and feed the cable
under the bolt and in the channel as shown.
1
3
4
2
2mm
5
6.
Pull the cable tight and tighten the anchor bolt
(5) to 0.25Nm.
5
6
0.25 N·m
7.
Use the barrel adjuster to remove cable slack.
8.
Trim the cable 30mm from the cable anchor bolt,
install a cable crimp (6) and tuck the cable into
the pulley pocket as shown. The cable end must
not protrude above the lockout pulley. This will
interfere with the compression adjuster knob.
9.
Lubricate the adjuster seal (7) with 5W or lighter
suspension oil. Do not use grease
10. Insert the compression adjuster knob (8) over
the splines (a) on the compression rod. Lightly
tighten the compression knob screw (9). Rotate
the compression adjuster knob fully clockwise then
fully counter clockwise to seat the compression
adjuster seal.
a
7
5W
8
0.85 N·m
9
11. Hold the compression adjuster knob
stationary with your fingers, tighten the screw (9)
to 0.85 Nm.
NOTICE
Over-tightening the screw (9) will result in compression
knob being difficult to turn or damage.
Summary of Contents for Lefty Ocho 120
Page 29: ......