7
Cleaning
When cleaning your bike, use a damp sponge or a soft brush with only a mild soap and water solution. Rinse the sponge often. Do not spray
water.
NOTICE
Do not use a pressure washer or dry with compressed air. This will force contaminants into sealed areas, electrical connections/
components promoting corrosion, immediately damaging, or result in accelerated wear.
WARNING
KEEP WATER AWAY FROM THE ELECTRICAL COMPONENTS.
MAKE SURE THE BIKE IS SECURED UPRIGHT AND CAN NOT FALL OVER ACCIDENTALLY WHILE YOU ARE CLEANING IT.
Don’t rely on the
kickstand. Use a sturdy portable bicycle wheel stand to hold the bike upright.
Tightening Torques
Correct tightening torque for the fasteners (bolts, screws, nuts) on your bicycle is very important to your safety.the durability and performance of
your bicycle. We urge you to have your Dealer correctly torque all fasteners using a torque wrench.
deScrIPtIon
nm
In Lbs
Loctite™
KICKSTAND MOUNTING
7.0
62.0
242 (blue)
REAR RACK MOUNTING BOLTS
3 - 4
26.5 - 35.4
STEM/HANDLEBAR CLAMP BOLTS
6.0
53.0
DROPOUT MOUNTING BOLTS
15
133
LEFTY CLAMP BOLTS
7-9
62-80
LEFTY WHEEL AXLE BOLT
15
133
If you decide to tighten fasteners yourself always use a good torque wrench!
Drive Unit
NOTICE
Drive unit is maintenance-free and must only be serviced at an authorized service center. This will ensure the quality and safety of
the driving unit. Never attempt to open, remove it from the frame, or work on it yourself. Other components of the eBike drive (e.g.
drive chain, front chain ring, rear cassette, rear derailleur, crankarm) must be serviced by your Cannondale Dealer. Replacement parts
must be identical to the original Cannondale specification for the bike. See
Specifications
. Failure to replace components with original
specification can result in serious overload or other damage to the drive unit. Unauthorized opening or service of the drive unit will void
the warranty. The drive system will not function without the computer unit attached to the base properly. If the computer disconnects
from the base during operation, the drive system will shut off. If this happens you will have to stop the bike, turn the system off , re-
attach the computer to the base, and then turn the system back on to resume. Remove the computer when not operating the bike to
prevent theft or unauthorized use.
EN
