10
10. Step 10 -
Engage the belt at the rear side of the pad to the buckle of the cross brace. Make sure you hear a
clicking sound.
11. Step 11 -
The bottom pocket of the pad should fit on the vibration unit. The front edges of the vibration unit
should go through the large opening at the front side of the pad.
12. Step 12
- Engage the buckle at each side of the pad around each side rail. Make sure you hear a clicking
sound.
13. Step
13
– Attach the plastic connectors of the toy bar into the openings of the rails. Press carefully until they
are fixed.
Hint:
The toy bar is detachable. Press on each side the buttons and in the same time lift the toy bar. Move the
button on the vibration unit under the icon for vibration (
≋
)
, in order to activate this function.
USE
1. Adjustment of the backrest position:
•
Upright position:
Press the buttons at the sides of the rails and at the
same time raise the seat towards you.
•
Tilted position:
While you press the buttons at the sides of the rail, tilt
the backrest backwards / downwards.
For reference see the attached scheme.
WARNING! In order to prevent serious injuries or death:
Use the
upright position of the seat only while the child has enough control over its
upper body in order to sit up straight without tilting forwards.
• Check in order to make sure that the restraint system is safely
attached by pulling it slightly sideways from your child. The
restraint system should remain attached.
•Tighten each waist belt so that the safety belts fit your child
snugly without causing discomfort to your child.
4. Adjustment of the belts
A. In order to tighten the belts:
• Insert the anchored end of the safety belt upwards through the
buckle, in order to form loop А. Pull the free end of the restraint
belt B.
2. Adjustment from bouncer function to chair function:
• Turn the kickstand so that it stands on the floor.
• Press the front part of the seat downwards in order to check whether the
kickstand is in the correct position.
3. Placing of the safety belts :
• Remove the toy arch and place the child on the seat.
• Place the crotch pad of the safety belt on your child. Fasten the belts through
waist on each side of the safety pad.
• Make sure that you hear a clicking sound on both sides.
B. In order to loosen the belts:
Insert the free end of the restraint belt up through the buckle in order
to form loop A. Enlarge the loop by pulling the end of the loop
towards the buckle. Pull the anchored end of the safety system in
order to shorten the safety belt.
WARNING! IN ORDER TO PREVENT SERIOUS INJURIES OR
DEATH: NEVER USE THE TOY BAR AS A HANDLE FOR
LIFTING/ CARRYING THE ROCKER.
