Candy FLE 0502/6 X, User Instructions

Page: 15 / 96

FUNCTION HOW TO ACTIVATE IT
MINUTE
MINDER
COOKING
TIME
END OF
COOKING
MANUAL
FUNCTION
HOWTO SWITCH ITOFF WHAT IT DOES WHAT IT IS FOR
To set the cooking time, turn dial one
complete revolution and then position the
index to the required time. When the time
has lapsed, the signal will ring for a few
seconds.
Reading of the
time selected
•Press and hold the
button
•Press the buttons or
to set the required time
•Release all the buttons
•When the set time as
elapsed an audible alarm
is activated (this alarm will
stop on its own, however
it can be stopped
immediately by pressing
the button) •Sounds an alarm at the
end of the set time.
•To check how long is left
to run press the button •Allows to use the oven as
alarm clock (could be
activated either with
operating the oven or with
out operating the oven)
•Press and hold the
TIMER button
•Press the buttons or
to set the lenght of
cooking required
•Release all buttons
•Set the cooking function
with the oven function
selector
•When the time is elapsed
the oven will switch off
automatically. Should you
wish to stop cooking earlier
either turn the function
selector to 0, or set time
to 0:00 (TIMER and
buttons) •It allows to preset the
cooking time required
for the recipe chosen
•To check how long is left
to run press the TIMER
button.
•To alter/change the
preset time press TIMER
and buttons •At the end of the cooking
set time, the oven will
switch off automatically
and an audible alarm will
ring.
•Press and hold the END
button
•Press the buttons
to set the time at which
you wish the oven to
switch off
•Release the buttons
•Set the cooking function
with the oven function
selector
• Press and hold the TIMER and END buttons ( and TIMER on some
models
• Set time with buttons
• Release all buttons
ATTENTION the oven only operates if set on manual function or preset time.
N.B.: on some models the symbols are replaced by + and - .
•At the time set, the oven
will switch off. To switch
off manually, turn the oven
function selector to
position O. •Enables you to set the
end of cooking time
•To check the preset time
press the END button
•To modify the preset
time press buttons END
+ •This function is typically
used with “cooking time”
function. For example if
the dish has to be cooked
for 45 minutes and needs
to be ready by 12:30,
simply select the required
function, set the cooking
time to 45 minutes and the
end of cooking time to
12:30.
•Cooking will start auto-
matically at 11:45 (12:30
minus 45 mins) and will
continue until the pre-set
end-of-cooking-time, when
the oven will switch itself
off automatically.
WARNING.
If the END of cooking is
selected without setting
the length of cooking
time, the oven will start
cooking immediately
and it will stop at the
END of cooking time set.
WARNING : the first operation to carry out after the oven has been
installed or following the interruption of power supply (this is
recognizable the display pulsating and showing )
is setting the correct time. This is achieved as follows
•Press the button
•Set the cooking function
with the oven function
selector •Enables you to operate
the oven. •For cooking the desired
recipes
To set the time, pull the control knob and turn clockwise to position at the correct time. To set as
minute minder, set the cooking time by turning clockwise the knob without pushing, until the
desired time is shown at the small window on the left of the clock (max. 180 minutes). When
the preset time is elapsed the alarm will ring and the oven must be switched off manually. To
stop the alarm turn the knob until appears in the window.
USING THE MINUTE TIMER USING THE END OF COOKING TIMER
USE OF THE ELECTRONIC PROGRAMMER
•Turn the oven function
selector to position O.
SETTING THE CORRECT TIME
10
20
30
40
50
60
70
80
90
100
11
0
120
15 GB
This control enables to set the desired
cooking time (max. 120 min.) the oven
will automatically switch off at the end of
the set time.
The timer will count down from the set
time return to the O position and switch
off automatically.
For normal use of oven set the timer to
the position.
To set the oven ensure the timer is not
on the O position.