Candy CHW938X ALG, Manual

Page: 9 / 40

9 9
TECHNICAL INFORMATION FOR THE
INSTALLER
In order to install the cooker top into the
kitchen fixture, a hole with the dimensions
shown in fig. 1.2 has to be made, bearing in
mind the following:
•
within the unit, between the bottom of the
cooktop and the upper surface of a shelf
there must be a clearance of at least 30
mm. It is absolutely essential that you
place a separator between the base of
the cooktop and the built-in unit or the
oven;
•
the cooker top must be kept no less than
200 mm away from any side wall (fig.
1.2);
•
the hob must be installed at least 60 mm
from the wall;
•
there must be
a distance of
at least 650
mm between
the hob and
any wall
cupboard or
extractor hood
p o s i t i o n e d
i m m e d i a t e l y
above (see fig.
1.1);
•
if the hob is
installed over a built-in oven, there must be a distance of at least 30 mm between the
two appliances. The two appliances shall be connected to the gas /electrical supply
with independent connections.
Fig. 1.2
Fig. 1.1
30 mm
Space for
connections
Clearance
Door
INSTALLATION IN KITCHEN
CABINET WITH DOOR
(fig. 1.3)
It is recommended that a 30mm clearance
be left between to base of the cooktop and
the separator.
The separator shall be heat resistant, made
of low thermal conductivity material and
shall be removable with the use of a tool for
installation and service.
Fig. 1.3
INSTALLATION
1
650 mm
60 mm min
200 mm min
500 mm
450 mm
860
480
500
60 min
840
200 min