page 4
SORELLE
( f )
( a )
Allen Head Bolts ( a )
Lock Washer ( f )
A
.
Attach the stabilizer bars to both the left and right sides (C&D) as shown.
B
.
Start by inserting the Barrel Nuts ( d ) into the predrilled holes in the
stabilizer bars. Refer to figure 1 to make sure the threaded hole in th center
of the Barrel Nut is properly aligned to capture the Allen head bolt ( a ).
NOTE: Make sure that the Barrel Nut is inserted with slotted end facing out.
C
.
To attach the stabilizer bar on the crib sides, insert the Allen head bolts ( a )
through the lock washers and flat washers, then through the pre-drilled holes
on the crib sides, and finally into the holes in the end of the stabilizer bars to
join with the barrel nut. Tighten with the Allen Wrench ( h ). Figure 1A. Repeat
on the 3 remaining corners.
(
d
)
Barrel Nut (d)
(
d
)
(
d
)
( h )
( e )
Flat Washer ( e )
Left side ( C )
Right side ( D )
( E )
( E )
Stabilizer bars ( E )