CandCNC RC-400, User Manual, Page: 3 / 51

3
23. Selected file LOADS to cut.
24. CODE DISPLAY shows G-CODE of loaded file, line
by line. Code can be scrolled UP and DOWN
25. G-Code line can be highlighted (Selected) for a
process
26. DRO DISPLAY Shows XYZA positions as code runs
27. Supports RUN PAUSE and STOP of code execution
28. Supports
RUN FROM function to start code at
selected LINE
29. Display Code as it runs and LINE NUMBER
30. Shows ACTUAL Feedrate in Real Time.
31. Allows Feedrate Override of +200 and -25 from
100%
32. DTHC panel displays when using Plasma Config.
33. Real Time Status display of UP/DOWN/DTHC
DELAY/and HOLD while running in Plasma Mode
34. Change PRESET VOLTS before or during a cut.
Bump bar with arrows.
35. Enable/Disable DTHC AUTO Mode
36. TURN DTHC ON/OFF
37. Disable TORCH fire for testing
38. DTHC ONLINE Status LED shows RS485 comm
status
39.
Changes to ROUTER display when a Router
CONFIG is loaded. Supports both SIMPLE
and new Stall Prevention Modes and
controls
40. Manual setup buttons for Router Bit Semi -
Automated Tool change (SATC ) with buttons
for Move to Tool Change preset and Perform
Tool Setter Move for first tool length offset.
41. Support for OXY – FUEL operation with
Manual Z Up and Down JOG while running
code (Manual THC)
42. Manual Override of Feedrate in all types of
cutting (FRO)
43. Running Code Pause and Resume at any
time
44. Screen Messages show up on Message Bar
on RC-400 screen including tool change
prompts
45. Supports RUN PAUSE and STOP of code
execution
46.Any Error codes show up in Message Bar