XB, HV, HVA, HVAR, ADD, ADDR, DDS, DDP, SXB, SADD
M0112_NOV 2020
Page 5 of 8
www.CANARM.COM
Canarm Ltd. - Corporate Head Office
2157 Parkedale Avenue, PO Box 367 Brockville, Ontario Canada K6V 5V6
Tel: (613) 342-5424 Fax: (613) 342-8437
www
.canarm.com
Canarm Ltd. uses pillow block bearings.
• Before removing the bearings mark the positions of the fan blade, bearings and pulley on the shaft.
• Note the clearance between the fan blade and the venturi.
• Remove the pulley and fan blade from the shaft using a puller.
• Unbolt the bearings and remove the shaft and pillow blocks as one unit.
• Clean the shaft and remove any marks using a file or emery cloth then remove the bearings using a bearing
puller.
• Inspect the shaft and replace if necessary.
• Mount the new bearings on a section of the shaft that is not worn by tapping the inner ring face using a soft
mallet.
• Align the setscrews on the bearings and then tighten one setscrew on each bearing.
• Loosely install the bearings on the bearing mount.
• Rotate the shaft to find the center of free movement.
• Install the propeller adjusting the bearing location to center the blade in the venturi.
• Tighten the bearing bolts to the proper torque rating
• Turn the propeller by hand the propeller should rotate freely with the same resistance as before the bearing
bolts were tightened.
• Tighten all setscrews to the proper torque rating
• Install pulley and adjust belt tension.
You should go through the start up steps as outlined above.
REPLACEMENT
PARTS LIST
MODELS: DDS, DDP, ADD, ADDR
MODELS: XB, HV, HVA, HVAR
4
3
2
1
MOTOR
1
WELDED FAN ASSEMBLY
PROPELLER BUSHING
FAN ASSEMBLY
PROPELLER
DESCRIPTION
QUANTITY
1
1
1
1
3
2
ITEM
4
DRIVEN SHEAVE BUSHING
MOTOR SHEAVE BUSHING
FAN ASSEMBLY
PILLOW BLOCK BEARINGS
3
DRIVEN SHEAVE
“V” BELTS
FAN SHAFT
PROPELLER
PROPELLER BUSHING
9
11
10
6
8
7
5
4
DESCRIPTION
MOTOR SHEAVE
ITEM
2
1
1
2
2
1
1
1
1
1
1
QUANTITY
1
1
WELDED FAN ASSEMBLY
MOTOR
4
11
9
10
6
8
7
5
2
3
1
