9
Press the temperature setting button to set an appropriate temperature. Press the heating button to heat the
water. Put on the lid while heating. When the water temperature reaches the fixed temperature, you can enjoy
your SPA. Press the jet massage button to activate massage system. We suggest that the appropriate temper-
ature is around 37-39
℃
in winter. The massage system will stop automatically after 30 minutes of operation to
reduce the energy consumption. Re-activate the Jet massage function by pressing the Jet massage button again.
See Part 7 for Control Functions.
Locking the buckle on spa lid cover
Press the sides of the buckle, push together to lock the buckle, press the sides of the buckle, to unlock the buckle.
5. Install the filter cartridge
Open the cartridge lid counter-clockwise. Then put the new filter cartridge into the pump and close the
cartridge lid clockwise.
6. Fill water
Note: Pre-fill check: ensure the drain outlet is extended for future draining/access (Fig. A). Check the stopper
on the bottom of the spa and the drain cap, make sure both of them are tight. Fill the spa with water using a
garden hose until reaching water level printed on the spa inner wall.
7. Release the airlocks from the pump
To remove an airlock turn on the control unit , select the filter function: the air in the pump must be
released ; Unscrew the air valve counter-clockwise, release the air until the water is coming out, then screw the
air valve clockwise tightly ; Use a towel to wipe off the pump.
Part 4
USAGE
(Fig. A)
8. Place the thermal blanket on the spa for easier
heating and to make the spa more efficient.
CLEANING/REPLACING FILTER CARTRIDGE
WARNING: RISK OF ELECTRIC SHOCK. Unplug the pump before beginning SPA maintenance.
Note: Dirty filter cartridge may contaminate the spa water and cause damage to the heating function.
1 Threaded outlet caps onto the inlet and outlet on the spa inner wall.
2 Unscrew the filter housing lid by turning it counter-clockwise. Take out the filter cartridge.
3 Rinse off the filter cartridge with a garden hose and reuse it. If the filter cartridge remains dirty and discoloured, the filter cartridge
should be replaced.
4 Put back the cleaned filter cartridge into the cartridge housing. Close the lid by turning clockwise.
5 Remove the caps from inlet and outlet on the spa inner wall, allow the water to flow into pump.
6 Repeat previously outlined steps: Do GFCI test, release air in the pump, and operate pump as needed.
Part 5
WATER MAINTENANCE
The quality of the water inside your hot tub can be harmful to your health if it isn’t properly taken care of. The filter cartridge should be
cleaned weekly and replaced when needed depending on use. Change water once a month or depending on use and use appropriate
spa chemicals.
Please pay attention to the chemicals used and dosage. SPA damage resulting from misuse of chemicals is not covered by the warranty.
1. Water Balance
We recommend you maintain your water balance: PH value: 7.2 - 7.6; Free chlorine: 2ppm - 3ppm
Purchase a test kit to test your spa water before each use of the SPA, or at least once per week.
2. Water Sanitation
We suggest to use Chlorine granular or Chlorine/ Bromine tablets to disinfect the spa’s water. (Chemical floater should be purchased
separately). Never put tablets directly on the spa liner.
3. Cleaning the SPA
Clean the SPA spa with soap and water, then rinse. Leave it outside (away from direct sunlight) to dry.
4. REPAIRS (Little holes or punctures can be repaired with the repair kit that comes with the SPA)
How to fix a leak in the spa liner:
1. Thoroughly clean the area surrounding the leak. Cut a piece of repair material in a round shape larger than the damaged area.
2 . Apply adhesive to the underneath side of the patch and around the area to be repaired. Completely coat the affected area with a light
layer of glue.
8
